First go, i don’t think i put enough pressure on the squeegee, and there were just a few streaks of ink in my print.
Next two tries, it was just a bit inconsistent.
Fourth try… well, i’m counting it as good even though it doesn’t look it.

I’m learning using a cheap-and-dirty screenprinting kit, figuring it’s enough to get me started and i can always buy proper stuff one piece at a time as i get the hang of this. It uses stencils instead of putting emulsion right on the screen, and for my very first stencil i went for cheap over durable and used wax paper instead of transparency film. Unfortunately by my fourth print it was getting a little bedraggled, hence the fuzzy edges and apparent extra beak in my fourth print.